 |
 | |
110-Piece Metric Machine Screw Assortment
Zinc Dichromate (Yellow Zinc) Plating |
|
| The assortment consists of metric machine screws in sizes commonly used on Porsches. The sturdy organizer box contains 110 Phillips Pan Head machine screws in diameters M3, M4, M5 and M6, and range in length (measured under the head) from 6mm to 20mm, depending on the screw diameter. The screws are plated in corrosion resistant zinc dichromate (yellow zinc)to provide the correct factory look. |
|
|
|
|
 | |
180-Piece Sheet Metal Screw Assortment
Zinc Dichromate (Yellow Zinc) Plating |
|
| The assortment consists of sheet metal screws in sizes commonly used on Porsches. The convenient organizer box contains 180 Phillips Pan Head sheet metal screws in diameters #6 (3.5mm), #7 (3.9mm), #8 (4.2mm), #10 (4.8mm) and #12 (5.5mm) and range in length (measured under the head) from 3/8 In. (9.5mm) to 1 1/4 In. (32mm), depending on the screw diameter. The screws are plated in corrosion resistant zinc dichromate (yellow zinc)to provide the correct factory look. |
|
|
|
|
 | |
160-Piece Trim Screw Assortment
Black Oxide |
|
| The assortment consists of trim screws and washers in sizes commonly used on Porsches. The sturdy storage case contains 110 black Phillips Oval Head trim screws in 3.5mm (#6), 4.2mm (#8) and 4.8mm (#10) diameters and ranging in length from 13mm (1/2 In.) to 32mm (1 1/14 In.), and 50 black zinc over brass (no rusting) flanged trim washers in the corresponding diameters. This assortment can be used for interior as well as exterior trim. |
|
|
|
|
 | |
Metric Wing Screws With Washers
Zinc Dichromate (Yellow Zinc) Plating |
|
| The wing screw holding the rear plastic fuse panel cover on your 911 fell into the engine compartment and you can't find it, or is it that it has turned ugly from years of use. Well, shame no more. Our metric wing screws are size M6 x 10mm and are plated with corrosion resistanct zinc dichromate (yellow zinc), just like the original one. There are 2 screws and 2 M6 penny washers per pack. |
|
|
|
|
 | |
| Window Frame Screws - Black Zinc |
|
| These metric oval head Phillips screws hold the top of the driver and passenger doors window/deflector divider frame upgrights on 911s and some other Porsche models. Better countersunk fit than the original ones. 2 screws per door. Black zinc finish, size M5 x 9.5mm (measured at the top of the countersunk, otherwise the length of the screw shaft is 7mm). A small detail but a contribution nonetheless to the overall appearance of your car. Takes 2 minutes and a Philipps screw driver. The screws come in packs of 4. |
|
|
|
|
 | |
| 911 Door Pocket Bottom Screws - Black Zinc |
|
| These metric flat head Phillips screws hold the bottom part of the door pocket on the driver and passenger doors on 911s. 3 screws per door. Black zinc finish, size M4 x 25mm (measured at the top of the countersunk, otherwise the length of the screw shaft is 21mm). The screws come in packs of 3. |
|
|
|